仪器简介:
Nonlinearity (% of F.S.)
=< ±0.15
=< ±0.07
Hysteresis (% of F.S.)
=< ±0.15
=< ±0.07
Nonrepeatability (% of F.S.)
=<±0.07
=< ±0.03
Accuracy (combined Nonlinearity, hysteresis and nonrepeatability, % of F.S.)
=<±0.15
=<±0.08
Stability, 6 Months (% of F.S.)
=<±0.20
=<±0.10
Rotational Effect on Zero (% of F.S.)
=<±0.10
=<±0.03
Calibration Accuracy (% of F.S. @ 75 deg F, traceable to NIST)
=<±0.05
=<±0.02
Temperature Effects:
Zero (% of F.S./deg. F.)
=<±0.003
=<±0.0015
Span (% of Rdg./deg. F.)
=<±0.003
=<±0.0015
Compensated Range
+75 to +175 deg. F
+75 to +175 deg. F
Minimum Useable Range
-25 to +185 deg. F.
-25 to +185 deg. F.
Storage Range
-65 to +225 deg. F.
-65 to +225 deg. F.
Zero Balance
=<±1% of F.S.
=<±1% of F.S.
Outputs: Fully bi-directional, dual outputs with characteristics as follows:
Clockwise (CW) Torque
+ 5 Volts
Counterclockwise Torque (CCW) Torque
- 5 Volts
Overrange (% of F.S.)
±33
Measurement Bandwidth:
High Frequency, dc to 500 Hz
Low Frequency, dc to 1 Hz
Power Supply Requirements:
10.5 to 24 Volts dc at 85 mA, nominal
技术参数:
扭矩范围:0.071-452400N-m, 过载:200%
信号输出:±5V,±10V,可以直接连接到PC,PLC或数据采集器
频率响应范围:1-500Hz
主要特点:
DC Operated Torquemeters are available in capacities from 25 lbf-in to 4,000,000 lbf-in with overload ratings of 2X full scale. Integral signal conditioning provides dual ±5 volt dc outputs proportional to torque. They will operate from a single power supply in the range of 10.5 to 24 volts dc (such as 12 volt batteries)
When installed between a driver and load, the sensor will measure static and dynamic shaft torque and speed (optional). A strain gaged stainless steel shaft senses torque and cancels bending and thrust. Robust, ferrite free rotary transformers connect the gages to noise immune carrier amplifiers. They don't generate noise or wear, are immune to magnetic fields, noise, vibration, lubricants and other hostile environments.
They are available in either shaft or flanged style configurations. Shaft end torquemeters are less costly than flanged models and can be either floated or foot mounted. Flanged models are much shorter and can be used when axial space is limited or when the highest shaft stiffness is needed
北京盛田嘉源科技有限公司为您提供非接触型直流扭矩传感器480,null480产地为美国,属于其它试验机,除了非接触型直流扭矩传感器的参数、价格、型号、原理等信息外,还可为您提供更多其它试验机,北京盛田嘉源客服电话400-860-5168转0689,售前、售后均可联系。